Service Hotline
Products

Qingdao Mountain Plastic extruding Equipment Co., Ltd.
Add: Nanguan Industrial Park, Jiaozhou, Qingdao, Shandong, China
Mobile Phone: +86-13606307135
E-mail: info@shansu-china.com

news
You are here: Home > news > Content
Matters needing attention in production operation of PET packing belt production line
Edit:Qingdao Mountain Plastic extruding Equipment Co., Ltd.   PublicDate:2019-11-06


Before starting the packing machine of the PET packing belt production line, check whether there are foreign objects in the barrel, the upper and lower parts of the hopper, whether the fastening bolts in each part are loose, whether the safety cover is firm, and whether the position of each button switch is correct. Then add enough oil to each lubricating part to do the cleaning and sanitation of the equipment. During operation of the equipment, do not touch any rotating parts with your hands. When the pet packaging belt production line is working, the operator must not leave the post. If you need to leave, stop the strapping machine. Remove the screws after parking, and apply a layer of rust-proof oil after cleaning the remaining materials. When not in use, hang them vertically in a dry and ventilated place. For packaging tape machines and forming dies that have not been used for a long time, they should be coated with anti-rust oil and sealed at the exit holes to prevent foreign matter from entering.

Matters needing attention in production operation of PET packing belt production line

1. When preparing to drive, inform the staff around the equipment to pay attention to safety.

2. When disassembling and installing the screw and mold, do not directly strike the parts with a heavy hammer. If necessary, pad a hardwood before striking or removing.

3. When cleaning the residual material on the screw, barrel and mold, it must be cleaned with a bamboo or copper knife and brush. It is not allowed to scrape the residual material with a steel cutter or grill the parts with fire.

4. At the initial stage of production, the minimum working speed of the screw is used, and the feeding should be small and uniform. At any time, check whether the working ammeter pointer of the motor that drives the screw rotates abnormally. Matters needing attention in production operation of PET packing belt production line

5. When handling the strapping machine failure, the strapping machine is not allowed to run. When the screw of the strapping machine is rotated and the mold is adjusted, the operator is not allowed to face the mouth of the extrusion barrel to prevent accidents.

6. The screw running test shall not exceed 30 minutes. After everything is normal, install the molds for production products and install the connecting bolts for the molds. Before use, apply a layer of molybdenum disulfide or silicone oil to facilitate disassembly.

7. Start the motor for driving the screw rotation at a low speed. Check whether the pointer of the main motor working ammeter is swinging normally. If there is abnormal sound during the operation of the equipment or the screw is not running smoothly, stop it immediately and ask the relevant personnel to repair it.

8. After the packing belt machine is put into normal production work, the operator should always check the temperature change of the bearing part. When checking the temperature of the motor and each bearing part, touch the inspection part with the back of your finger. Matters needing attention in production operation of PET packing belt production line


Qingdao Mountain Plastic extruding Equipment Co., Ltd.

Service Hotline

Mobile  E-mail:info@shansu-china.com

Address:Nanguan Industrial Park, Jiaozhou, Qingdao, Shandong, China  TelePhone:  MobilePhone:+8613606307135